Fitting the lighting components.

IMG_2552

IMG_2558

 

When designing the boxes with self supporting hinges I always wanted to use LED tape that would run around the sides of the boxes to give an even illuminance. The neatest way of installing this is to solder these little connections to the end of a length of LED tape, this will then fit into a connection with a 12 volt DC plug at the end.

The wood is too thick for the fitting to be screwed into the holes which I measured before adding to the laser cut files. So the section where the fitting is has been routed out (I am not allowed to use this equipment myself, so I have had no control over the size of the routed section). The MDF piece was, unfortunately, cut before these components were sourced, so the hole is slightly too big (by chance it was almost the right size!). For this one the component has been fixed into the hole using Araldite, which got a bit messy as the technician decided to use a heat gun to speed up the setting of the glue, but instead melted it. I have now managed to gently chisel off most of the glue.



Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s